Learn how to turn off your airbag light and fix a horn that doesn't work by replacing your clock spring. Replacing a clock spring is very simple, saves us over $600 and takes less than an hour. I will show you how to safely remove the airbag and steering wheel so you can replace the clockspring at home using common hand tools. To figure out I had a bad clock spring, I used an obd2 scanner to scan the airbag light and got codes b1801 and b1811 which is an open squib circuit, which means the clock spring is bad. Another way to tell the clock spring is bad is the horn doesn't work and/or the steering wheel buttons don't work.
OBD2 Scanner (BlueDriver):
Service Manual for Torque Specs:
Steering wheel puller:
Torque Wrench:
Ratchet:
Threadlocker:
Clock spring:
→ As an Amazon Associate I earn from qualifying purchases.
→ Become a ChrisFix Subscriber:
→ Instagram:
→ Facebook:
→ Website:
→ My Channel Home Page:
**If the video was helpful, remember to give it a "thumbs up" and consider subscribing.**
Disclaimer:
Due to factors beyond the control of ChrisFix, I cannot guarantee against improper use or unauthorized modifications of this information. ChrisFix assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. ChrisFix recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of ChrisFix, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not ChrisFix.
0 Comments