B&O compatible adapter cable based on audio cable in good quality, fitted with gold plated phono plugs and trigger cable fitted with Mini Jack (mono) male connector to use 12V trigger from 3rd party surround / stereo equipment. The cable comes out in an 8-pin DIN female connector that gives the opportunity to pass signals in existing or new Powerlink cables. The cable is constructed with an internal 12-5 volt step-down for the protection of B&O Beolab speakers Powerlink port, that normally is specified for max 5V (2.5V-5V in switched mode) and when you use a cable without internal step-down, you will supply the speakers Powerlink port with 12 Volt, which at worst case can short circuit the powerlink part of the speaker. Notice that this adapter cable takes care of the problems you have when using third-party stereo or surround equipment with a 12V trigger for on/off of external devices.
Some active B&O Beolab speakers have a standard. line input (RCA 'Line'), which the speaker can trigger on and it is basically also a good solution with a third-party system which is used for music, but when you use B&O Beolab speakers in a surround setup, there is a risk that the speaker switches off during quiet passages in the movie and the speaker then can take a while to start up when there is passages with sound again. The problem with on and off switching does not happen with this trigger cable, since it ensures that the speaker is turned on as long as the amplifier (trigger) is on (remember that the little switch in B&O speaker must be either ' L 'or' R 'depending on whether it is Left or Right speaker).
Trigger adapter:
Stereo to Powerlink:
Mono to Powerlink:
Stereo (USB) to Powerlink:
About AV-Connection:
Website:
Facebook:
Linkedin:
Instagram:
Please contact us on mail info@av-connection.com or by phone +45 74421078
0 Comments